PanaVise Custom InDash Mount for the Cadillac Escalade
Model #: 75109-807
The Panavise InDash Custom Mount eliminates exposed holes in vehicle for clean easy and nearly invisible phone mount installation. Proudly made in the USA from the highest quality heavy gauge steel this Panavise Custom Indash Mount has been fitted and produced specifically for your car to provide the utmost convenience and practicality. Complete mounting instructions are included with your purchase and are also available below.
Compatible Cars:
- 2007-2012 Cadillac Escalade
- 2007-2012 Cadillac Escalade ESV
- 2007-2012 Cadillac Escalade EXT
Mounting Instructions
- MOUNTING LOCATION: Right side of Radio
- TOOLS REQUIRED: Plastic Dash Tool Hook Tool 9/32"(7mm) Socket Driver
- HARDWARE INCLUDED: None
Step# 01
Begin by CAREFULLY removing the dash plate between the glove box and the airbag. Start by inserting the plastic dash tool in the bottom left of the plate by the split to the right side of the center right air vent. Pry to release (1) clip. Move over about 4" and pry to release another clip. Pull the cover towards you to release (2) upper clips. Continue to the right to release the final (2) clips to left of the passenger air vent.
Step# 02
Remove the console bezel that includes the cup holders and ashtray by inserting the plastic dash tool back by the split of the bezel to left or right side of the console storage box. This bezel is about 1/8" thick please use caution. Pull up to release (1) clip each side. With hook tool assist CAREFULLY pull up on the front of the console bezel to release (2) clips. Disconnect plug(s) and set cover aside.
Step# 03
Begin to remove the bezel that surrounds the radio disk players climate control and switches. Start at the bottom right and left side by the switches. Pull to release (1) clip on each side. Work your way under the bezel up to the next (2) clips just below the air vents. Tilting and pulling out to release (2) final clips on top of the air vents. Release the bezel completely and disconnect the plugs as necessary.
Step# 04
With 9/32" socket driver remove the (1) screw located to the right of the disk players. Place InDash by PanaVise Mount over the screw hole with the mount to fit to the right side of the dash cavity and replace screw.
Step# 05
Replace the radio bezel plugs then starting at the top pushing straight in to secure the (2) top clips. Continue down the bezel pushing in the last clip below the InDash Mount last. You may need to adjust the angle of the mount slightly to get the bezel to fit in place correctly. Continue to the cup holder bezel carefully installing the front first watching for the pins to fit correctly into the radio bezel. Finally replace the dash plate above the glove box starting from the left side.
If we don't have it listed please email us.
