PanaVise Custom InDash Mount
Model #: 75112-508
The Panavise InDash Custom Mount eliminates exposed holes in vehicle for clean, easy, and nearly invisible phone mount installation. Proudly made in the USA from the highest quality heavy gauge steel, this Panavise Custom Indash Mount has been fitted and produced specifically for your car to provide the utmost convenience and practicality. Complete mounting instructions are included with your purchase and are also available below.
Compatible with:
MOUNTING INSTRUCTIONS
Mounting Location: Right side of radio/cubby JM R
Hardware Included: (2)-O- 8/32" Acorn Nuts
Tools Required: Dash Tool, T-20 Torx Driver, 5/16" wrench
Step# 01
With Dash tool release the bezel around the Radio, climate control, and Instrument panel all the way to the drivers door, and includes the air vents and switches enough to get at the (1) Torx screw to the right of the cubby above the radio.
Step# 02
Place InDash Mount bottom over the screw hole and plastic pin. Replace the screw. Replace the bezel.
Step# 03
Insert the top part (w/studs) into the bottom part . Install the (2) cap nuts supplied and tighten with the 5/16" wrench
If we don't have it listed please email us.
