Brand New PanaVise Custom InDash Mount for the2001-2006Hyundai Santa Fe
Model #: 75118-501
ThePanavise InDash Custom Mount eliminates exposed holes in vehicle for clean, easy, andnearly invisible phone mount installation. Proudly made in theUSA from the highest qualityheavy gauge steel, this Panavise Custom Indash Mounthas been fitted and producedspecifically for yourcar to provide the utmost convenience and practicality. Complete mountinginstructions areincluded with your purchase and are also available below.
Mounting Location:Right side of radio
Tools Required: Hook Tool andPhillips Screwdriver
Hardware Included: None/P>
Open and remove ashtray. With Phillips screwdriver, remove (2) screws on each side of the ashtray cavity. With your hands or hook tool pull on the bottom left side of the bezel surrounding the ashtray, power outlet, and climate control, to release (1) clip. Repeat on the right side also.
Insert hook tool into the top of the climate control bezel, right or left side, and pull to release (1) clip. Repeat on other side same area. Pull out climate control enough to get to the (2) Phillips screws that are under the radio bezel on the right and left sides, vertically positioned. Remove these (2) screws.
Place clean shop towels on console, and dash top to avoid scratches. Lift up on the bottom of the radio/air vent bezel. Pull to release (2) clips. Continue by lifting up slightly and pulling the whole bezel towards you to release the last (3) clips. Set bezel up on top of the dash on the towel to protect the dash.
Remove (2) Phillips screws from the right side of the radio. Place the InDash by PanaVise over the screw holes and replace screws. Reinstall the bezel with air vents by pushing it back in. Replace the (2) screws. Replace the climate control bezel with (2) screws. Replace ash tray.
If we don't have it listed please email us.