PanaVise Custom InDash Mount for the1995-2009Mercury Grand Marquis
Model #: 75125-195
ThePanavise InDash Custom Mount eliminates exposed holes in vehicle for clean, easy, andnearly invisible phone mount installation. Proudly made in theUSA from the highest qualityheavy gauge steel, this Panavise Custom Indash Mounthas been fitted and producedspecifically for yourcar to provide the utmost convenience and practicality. Complete mountinginstructions areincluded with your purchase and are also available below.
MOUNTING LOCATION:Right side of climate sensor
TOOLS REQUIRED: 9/32" Nut driver and Phillips screwdriver
HARDWARE INCLUDED: (2) self-drilling screws
Step # 01
Remove the horizontal, full-width trim strip which is above the climate control and the glove compartment. This is done by using your hands. Carefully pull on the right end of the trim strip: this will release the clips. Disconnect the clock wires and set trim strip aside.
Step # 02
Remove the 9/32" screw located directly under the right side of the air vent which is directly on the right side of the radio.
Step # 03
Attach phone holder to InDash Mount. If using a PortaGrip holder, adjust to size of phone prior to mounting.
Slide the InDash Mount under the flange where the screw was removed and re-install screw when in position. Add the two supplied, self-drilling screws.
Reconnect the clock wires and push trim panel back into place.
If we don't have it listed please email us.